Cascade X-15

The X-15 Stereo ribbon microphone houses two separate matched ribbon motors that are positioned one above the other. The elements are offset 90 degrees and are configured in the Blumlein setup. Stereo separation is superb and off-axis coloration is minimal. Add in the excellent sensitivity and frequency response range the X-15 is ready for the big leagues.

Unlike most ribbon motors designed today with an offset ribbon element, the new Cascade X-15 houses two hand-tuned ribbon elements that incorporate the legendary symmetrical ribbon design. This design offers a true figure 8 pattern. The corrugated aluminum membrane itself is positioned in the center from front to back, thus producing a balanced audio input signal to both sides of the ribbon assembly.


The fit and finish are of top quality and includes a premium  suspension shockmount, thick padded vinyl pouch and an upgraded aluminum case. A 5-pin cable is included, the cable connects to a metal splitter box where two separate XLR connectors give access the to upper and lower ribbon motors.

Applications : Drum overheads, guitar cabinets, acoustic guitars, horns, piano, room ambiance, Percussion, choir, Orchestra.


Cascade X-15 Stereo Ribbon Mic Includes :

• Cascade X-15 Stereo Ribbon Microphone
• Premium Suspension mount
• Wind filter
• 30ft. 5-Pin XLR cable
• Metal splitter box
• Thick padded vinyl pouch
• Micro-fiber cleaning cloth
• Specifications and measurements from Cross-Spectrum Labs

Cascade thoroughly inspects the audio and built quality of each and every Cascade microphone before it leaves the shop;
once you try one...you'll be a believer.


Note:
As with all ribbon type microphones, the X-15 is not suitable for instruments that produce air-pressure, i.e. kick drum or blowing directly into the grill.

Cascade X-15 Stereo Ribbon Mic Specifications :

• Type: Stereo Ribbon (velocity) Microphone
• Polar pattern: Figure 8
• Ribbon type & Dimensions: 99% Pure aluminum, 2 X 2.5 micron, 1 3/4" (L) X 3/16" (W)
• Sensitivity: -51.7 dB +/- 2 dB (2.6 mV/Pa)
• Frequency response: 30 to -18,000 Hz (+/- 3dB)
• Output Impedance: <=200 Ohms
• Recommended load impedance: >1000 Ohms
• Max.SPL (1% THD @1000 Hz): 145 dB
• Connector: Heavy gauge 5-Pin male XLR
• XLR Pin-out: Lower Ribbon, Pin 1 Hot, Pin 2 Cold, Upper Ribbon, Pin 4 Hot, Pin 5 cold, Pin 3 ground