Dynaudio M2 (Pair)
Passive Precision Midfield Monitors with Dual 8.25" Woofers, 3" Soft Dome Midrange, and 1.25" Silk Dome Tweeter
|
If you’re looking for a midfield monitor system that can deliver high SPLs with accuracy, the M2 is the choice. This three way, ported design is just the right size and shape to serve as main monitor system in a mid sized control room. The two 8.25-inch woofers, 3 inch soft dome midrange and 1.25 inch soft dome tweeter, produce a full frequency response that reaches from 34 Hz to 20 kHz, and Dynaudio QC insures that each monitor will be matched to any other monitor within ± 1.5 dB.
|
Stereo imaging is pinpoint accurate thanks to the computer optimised designs of the crossover and drivers, and the M2 is capable of SPLs of up to 125dB at 1.25m as a stand alone system. When combined with a pair of Dynaudio Acoustics subwoofers, the system becomes a full 4 way main monitoring system capable of very high SPLs with a full frequency response down to below 35Hz.
The original design concept for the M2 was a compact near-to-midfield monitor, which would remove the need for larger built-in systems with their inherent problems of accuracy, installation and cost.
Every component of the M2 has been designed for both quality of reproduction and extreme reliability, and each driver can comfortably handle very high transients with no degradation of signal or components, leading to an outstanding dynamic response when coupled with a suitable amplifier with good current capabilities.
The result is a system which, in its various configurations, is the most flexible monitor package ever designed. By combining M2 with Dynaudio Acoustics subwoofer systems, it is possible to use one basic package for anything from desktop to
main monitoring.
The M2 is essentially flat from 45Hz to 20Hz, and the specially designed bass, mid range and high frequency drivers are capable of reproducing impulsive transients of up to 1000W each without compression.
Dynaudio M2 Specifications : - System : 3-way Passive Midfield/Main Monitor
- Recommended amplifier: 250W to 500W
- Frequency Response (+/- 3 dB) : 34 Hz - 20 kHz
- Peak SPL 1m, pair (IEC Short Term) : > 130 dB peak
- Peak SPL 2m, 5.1 (IEC Short Term) : > 131.5 dB peak
- Amplifier minimum : 100 W (> 100 dB SPL @ 2m)
- Sensitivity (2.83 V/1m) : 91 dB
- Impedance, Nominal : 4 ohm
- Impedance, HF (200 kHz) : 9,6 ohm
- Resonance Frequency : 45 Hz
- Internal Cabinet Volume : 70 liters
- Bass Principle : Bass reflex
- Crossover Frequencies : 900/4500 Hz
- Crossover Slope : Woofer 12 dB/oct; Midrange 12 dB/oct; Tweeter 18 dB/oct
- Tweeter : Esotec 28 mm soft dome Magnetic fluid, Rear chamber, Pure alu wire voice coil, 4 mm die-cast alu front
- Midrange : 75 mm soft dome, pure alu wire voice coil
- Woofer ; 21 cm, polypropylene cone, 54 mm pure alu wire voice coil
- Weight : 36.3 kg / 80 lbs
- Dimensions (WxHxL) : 340 x 680 x 500 mm
|
![]() |
More Images (click to select)
Roll over the image on the left for a closeup view.
|
|
|
|
