Meyer MILO 60 Array Loudspeaker
|
A variation on the popular MILO highpower curvilinear loudspeaker, the MILO 60 high-power narrow coverage curvilinear array loudspeaker excels where controlled horizontal coverage is needed. The selfpowered MILO 60 is a compact, lightweight four-way system that provides 60 degrees of horizontal coverage, and vertical coverage matching the original MILO. The coverage pattern is optimized for applications requiring tight horizontal cover age, such as at the top in mixed arrays with standard MILO or M3D line array loudspeaker systems, or for side fill hangs where keeping sound off of side walls is important.
|
Controlled horizontal coverage angle of 60
degrees
Patented REM ribbon emulation manifolds
dramatically minimize distortion
Exceptional fidelity and peak capability
assure clean, high-impact response
Seamless integration with other M Series
models
QuickFly rigging system simplifies use in
flown or ground-stacked arrays
Applications
Stadiums, arenas, concert halls and theaters
Touring sound reinforcement
Large-scale events
Acoustical
Operating Frequency Range: 60 Hz - 18 kHz
Frequency Response: 65 Hz - 17.5 kHz ±4 dB
Phase response: 750 Hz - 16 kHz ±30°
Maximum Peak SPL: 140 dB
Dynamic range: >110 dB
Horizontal coverage: 60°
Vertical coverage: Varies, depending on array length and configuration
Acoustical crossover: 560 Hz, 4.2 kHz
Transducers
Transducers: Low/Low-Mid Frequency
Two 12" cone drivers with neodymium magnets
Nominal impedance: 4 Ω
Voice coil size: 4"
Power-handling capability: 1200 W (AES)
Transducers: Mid-High Frequency
One 4" compression driver
Nominal impedance: 8 Ω
Voice coil size: 4"
Diaphragm size: 4"
Exit size: 1.5"
Power handling capability: 250 W (AES) on REM
Transducers: Very-High Frequency
Three 2" compression drivers
Nominal impedance: 12 Ω
Voice coil size: 2"
Diaphragm size: 2"
Exit size: 0.75"
Power handling capability: 100 W (AES)on REM
Audio Input
Type: Differential, electronically balanced
Max. common mode range: ±15 V DC, clamped to earth for voltage transient protection
Connectors: Female XLR input and male XLR loop output or VEAM connector
Input impedance: 10 kΩ differential between pins 2 and 3
Wiring: Pin 1: Chassis/ earth through 220 k Ω, 1000 pF, 15 V clamp network to provide virtual ground lift at audio frequencies
Pin 2: Signal +
Pin 3: Signal -
Case: Earth ground and chassis
DC Blocking: None on input, DC blocked through signal processing
CMRR: >50 dB, typically 80 dB (50 Hz - 500 Hz)
RF filter: Common mode: 425 kHZ
TIM filter: <80 kHz, integral to signal processing
Nominal input sensitivity: 0 dB V (1 V rms, 1.4 V pk) continuous is typically the onset of TPL limiting for noise and music.
Input level: Audio source must be capable of producing a minimum of +20 dBV (10 V rms, 14 V pk) into 600 Ω in order to produce maximum peak SPL over the operating bandwidth of the loudspeaker.
Amplifiers
Amplifier type: Complementary power MOSFET output stages (class AB/H)
Output power: 3935 W (four channels; 3 x 1125, 1 x 560 W)
THD, IM TIM: <.02%
Load capacity 4 Ω low, low-mid and very-high channels; 8 Ω mid-high channel
Cooling: Forced air cooling, 4 fans total (2 ultra-high-speed reserve fans)
AC Power
AC power connector: 250 V AC NEMA L6-20 (twist lock) inlet, IEC 309 male inlet or VEAM connector
Voltage Selection: Automatic, two ranges, each with high-low voltage tap
Safety Agency Rated Operating Range: 95 V AC – 125 V AC, 208 V AC - 235 V AC; 50/60 Hz
Turn-on and Turn-off Points: 85 V AC – 134 V AC; 165 V AC - 264 V AC
Idle current: 1.1 A rms (115 V AC), 0.55 A rms (230 V AC), 1.3 A rms (100 V AC)
Max. Long-term Cont. Current Draw (>10 sec): 11.2 A RMS (115 V AC); 5.6 A RMS (230 V AC); 12.9 A RMS (100 V AC)
Burst current (< 1 sec): 14.4 A rms (115 V AC), 7.2 A rms (230 V AC), 16.6 A rms (100 V AC)
Ultimate Short-Term Peak Current Draw: 32 A rms (115 V AC), 16 A rms (230 V AC), 37 A rms (100 V AC)
Inrush current: 7 A rms (115 and 110 V AC), 10 A rms (230 V AC)
|
![]() |
More Images (click to select)
Roll over the image on the left for a closeup view.
|
|
|
|
