Chandler LTD-1
Single Channel Vintage Style Mic Preamp and Instrument DI with Class-A Amps and Transformers, and Double EQ Section
Want the classic Neve 1073 channel-amp sound but don't want to spend four-grand for an un-powered, 30-year-old module?
Built new and enhanced with extra frequencies, Chandler's LTD-1 mono-preamp and 3-band EQ will get transport you to that classic British tone-zone where presence and punch rule the day!
The Chandler Limited LTD-1 is a hand wired 1073 equalizer and pre amp that has been handmade using parts and build techniques from the original manufacture of the modules. Grounding, wiring techniques, original transformers, transistors, and inductors and much more attribute to the special sound of these units and have been painstakingly recreated in each LTD-1. We even make our chassis to resemble the old modules- highly polished plated steel.
In addition to the classic 1073 sound we add all the modern functions you expect and expand the EQ section giving you much larger palate to choose from. Features include high impedance direct in, 48v switching, output fader, eq in/out, phase reverse, balanced mic in, balanced line in, over built power supply to ensure maximum headroom, and nine additional eq points.
Mic/Line input sensitivityThis switch selects between the mic or line inputs on the rear panel, and attenuates the selected input. The right side of the switch is the line input which gives 30db of control over the signal. The bottom and left side of this switch control the mic input and gives from 20-80db of boost.
Equalizer
The LTD-1 features a greatly enhanced EQ selection that was borrowed from consoles that were custom ordered by the BBC from Neve, Calrec, Audix and others. It is a three band EQ that offers very good coverage of the bands and very musical selection of EQ points. The overall effect is the same great 1073 sound with about double the selection and the ability to be used in more situations with greater effect.
High EQ
This is a high end shelving characteristic with five selections. 16k, 12k, 6k8, 4k7, 3k3 (standard 1073s had only 12k).
Mid EQ
This is a mid frequency peaking characteristic with ten selections. 270hz, 390hz, 560hz, 820hz, 1k2, 1k8, 2k7, 3k9, 5k6, 8k2. (old 1073s had 360hz, 700hz, 1k6, 3k2, 4k8, 7k2).
Low EQ
This is a low end shelving characteristic with four selections. 220hz, 110hz, 60hz, 35hz. These are the same as found on classic 1073s.
Filter
This is a high pass characteristic with 3db loss at 300hz, 160hz, 80hz, and 50hz. These are the same settings as vintage modules.
Output
This functions as the fader on a mixing console. Use it to adjust between the 5db steps of the input or to run the input hot without distorting your recorder (for extra coloration). Most times this will be left at the full position.
Connections
All connections are transformer balanced with pin 2 hot.
Chandler LTD-1 Features :
- High EQ points 16k, 12k, 6k8, 4k7, 3k3
- Mid EQ points 270hz, 390hz, 560hz, 820hz, 1k2, 1k8, 2k7, 3k9, 5k6, 8k2
- Low EQ points 220hz, 110hz, 60hz, 35hz
- Filter Points 300hz, 160hz, 80hz, 50hz
- Mic impedance 1200Ω
- Line impedance 10kΩ
- Output impedance 600Ω
- Noise Better than -85 dbm at -35dbm sensitivity.
- Output Maximum output +28dbm
- Frequency response flat 15hz-20khz
- -3db 7hz 35khz
- Requires Chandler Power Supply PSU-1
Chandler LTD-1 Specifications :
- High EQ points 16k, 12k, 6k8, 4k7, 3k3
- Mid EQ points 270hz, 390hz, 560hz, 820hz, 1k2, 1k8, 2k7, 3k9, 5k6, 8k2
- Low EQ points 220hz, 110hz, 60hz, 35hz
- Filter Points 300hz, 160hz, 80hz, 50hz
- Mic impedance 1200Ω
- Line impedance 10kΩ
- Output impedance 600Ω
- Noise Better than -85 dbm at -35dbm sensitivity.
- Output Maximum output +28dbm
- Frequency response flat 15hz-20khz
- -3db 7hz 35khz
- Requires Chandler Power Supply PSU-1
|
![]() |
More Images (click to select)
Roll over the image on the left for a closeup view.
|
|
|
|
